Solar System Model
|
Supplies needed:
|
 |
 |
Find the center of the large cardboard circle by drawing a line
from top to bottom and a line from right to left. Where these two lines meet
is the center of the circle. This will be the position of the Sun.
|
 |
Using a compass, draw the orbits of the 9 planets (draw circles
around the center of the piece of cardboard).
The first 4 planets orbit relatively close to the Sun, then
there is a gap (this is where the asteroids orbit).
Then the last 5 planets orbit very far from the Sun. |
 |
Using an awl, the sharp point of scissors, or a large nail, punch
a series of holes in the cardboard. First punch a hole in the center (this is
where the Sun will hang). Then punch one hole somewhere on each circle
(orbit); a planet will hang from each hole.
. |
 |
 |
Cut circles from oak tag to represent the Sun and each of the
planets. Since the range in size of the Sun and the planets is far too large
to represent accurately, just make the Sun the biggest. Make Jupiter, Saturn,
Uranus, and Neptune a bit smaller than the Sun. Make the remainder of the
planets much smaller. Saturn has beautiful rings.
Write the name of each planet on its back. |
 |
Tape a length of string to each planet (and the Sun).
Lace the other end of each string through the correct hole in
the large cardboard circle (Mercury goes in the inner orbit, Venus goes in
the second orbit, Earth goes in the third, etc.). Tape the end of the string
to the top side of the cardboard.
After all the planets (and the Sun) are attached, adjust the
length of the strings so that the planets (and Sun) all lie in a plane.
|
 |
To hang your model, tie three pieces of string to the top of the
cardboard - then tie these three together. Tie them to a longer string (from
which you'll hang your model).
You now have a model of our solar system. |
No comments:
Post a Comment